![]() You may or may not like the, but if you’ve been struggling, I hope this gives you a good starting point. Halo Suppression: 0 - 30 - This can help if your edges are looking a bit over-sharpened.Īgain, these are just my settings. Sharpening Amount: 50 - 150 (The default is too sharp in my opinion).Most of it’s the same, but with the following exceptions : For the A7IIįor the A72 I do things a little differently. ![]() I would rather have a small amount of image grain, than a processed look. I also thing the threshold, which defaults at 1 gives the image a slightly “digital” look, but, again, that’s just my opinion. I think the noise reduction setting is definitely too high by default though. Obviously, you will need to change these based on your own preferences. ![]() Luminance: 10 - 30 (raise for higher ISO)Īs you can see, there’s not a huge difference here, but these few settings, I think make a big improvement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |